Me postulé a través de una facultad o universidad. Acudí a una entrevista en Texas Instruments (Surathakal) en ago 2015
Entrevista
There was an online test conducted, it contained questions on Analog, Digital, Aptitude which was two hour long in totality. Around 10 were shortlisted for interviews for Analog and Digital profiles. Both had two tech rounds and an HR for selection. First round interview, questions were on RC circuits, opamps, networks, Mosfets.
Preguntas de entrevista [1]
Pregunta 1
Time response of Voltage across capacitor in an RC circuit being excited with different inputs (step, ramp, triangular, pulse). Viewing RC series as Low pass filter. Questions on Virtual grounding in opamp.
Acudí a una entrevista en Texas Instruments (Bengaluru)
Entrevista
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
Acudí a una entrevista en Texas Instruments (Bangalore Rural)
Entrevista
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.