Me postulé en línea. El proceso tomó 5 semanas. Acudí a una entrevista en Arm (Cambridge, East of England, England) en jul 2011
Entrevista
Can be divided into two parts, the phone interview, and the final face to face interview.
Both of them were VERY technical in nature and competency questions were absent. Questions related directly to Logic circuits, Logic Systems, VLSI, Solid state electronics and transistor physics. The interview itself is very grueling, in that questions are asked till you are at the very end of your knowledge and put your hands up and say that you don't know anything about what they have asked, and that point is used as a measure of how well you know your stuff. I thought I did terribly on both occasions, in that I did reach points at which I could not answer a question anymore, but I had in fact done quite well in actually arriving at that point.
Preguntas de entrevista [1]
Pregunta 1
Was related to the effect of clock gate cloning and de-cloning.
Me postulé a través de una recomendación de un empleado. Acudí a una entrevista en Arm (San Diego, CA) en abr 2026
Entrevista
1st was a hirevue interview - basic behavioral questions
2nd round was a panel interview - discussion on your resume and technical questions related to power and designing low power circuits
Preguntas de entrevista [1]
Pregunta 1
Given two processors, how would you determine which is better in terms of power (think about frequency, VDD, temperature etc)
Given a boolean logic, how would you reduce power in this
CV and then virtual interview then final interview through online call. It was basic interview about CV and some technical questions. It was not too difficult and intimidating. Technical interview depends on the role you apply for.
Preguntas de entrevista [1]
Pregunta 1
What was a difficult problem you encountered during your studies and how did you overcome it.
Interview was done online remotely with a manager and a graduate employee. General questions about previous experience and CB. Then followed by a live code session in Arm assembly with various technical questions.