Me postulé en línea. El proceso tomó 4 semanas. Acudí a una entrevista en Arm (Sheffield, Inglaterra) en jul 2017
Entrevista
Its very smooth and happens in a structured manner.
You would first be interviewed over phone or Skype within 10-15 days of application. In this you are asked mostly about whats in your CV, in detail.
Following this, if successful, you would be called for a face to face interview again within 10 to 15 days, also based on your convenience. However, if not through from previous step you would receive a detailed email, again in a short span of time.
In the face to face interview, you would first have to talk about yourself, projects, say whatever best describes your capabilities, then there would a 2 to 3 technical questions, based on area of application. Its very warm and friendly, usually with two interviewers, in a small meeting room.
All the best to aspirants. Its a wonderful experience, here at ARM. See you soon!
Preguntas de entrevista [1]
Pregunta 1
Tell something about a project of yours and what was the most difficult part of it and what was the good parts about ir.
Me postulé a través de una recomendación de un empleado. Acudí a una entrevista en Arm (San Diego, CA) en abr 2026
Entrevista
1st was a hirevue interview - basic behavioral questions
2nd round was a panel interview - discussion on your resume and technical questions related to power and designing low power circuits
Preguntas de entrevista [1]
Pregunta 1
Given two processors, how would you determine which is better in terms of power (think about frequency, VDD, temperature etc)
Given a boolean logic, how would you reduce power in this
CV and then virtual interview then final interview through online call. It was basic interview about CV and some technical questions. It was not too difficult and intimidating. Technical interview depends on the role you apply for.
Preguntas de entrevista [1]
Pregunta 1
What was a difficult problem you encountered during your studies and how did you overcome it.
Interview was done online remotely with a manager and a graduate employee. General questions about previous experience and CB. Then followed by a live code session in Arm assembly with various technical questions.