Me postulé a través de un reclutador. El proceso tomó 2 semanas. Acudí a una entrevista en Apple (Cupertino, CA)
Entrevista
Two Skype interviews and they flew me in for on-campus interview. The apple travel services was very convenient. Two of the interviewers had to leave on a last minute trip so I only had 6 people to interview.
Almost everyone were nice and friendly, interview is very casual and comforting. People are super busy there and you can totally fell that they want to get out of this interview room and back to work.
The interview goes to very basic physics questions. Don't waste your time preparing for a professional question.
Preguntas de entrevista [4]
Pregunta 1
Two Glass sheets are attached to each other using adhesive material, The combination is siting on two points of contact at both ends ( one rolling and one stationary ), We are applying a vertical force F to the center of top glass and combination deflects. How do we reduce the deflection?
We are throwing a ball into a friction-less cone, what should be the initial speed of the ball so it can orbit around the vertical axis of the cone indefinitely?
We have a cup of hot coffee and a small cold milk out of the fridge. The room temperature is in between these two. When should we add milk to coffee to get the coolest combination earliest ( at the beginning, in the middle, or at the end)?
The interview went well overall. The interviewer opened with a discussion about a project I'm proud of, then a beam scenario question that covered structural and load analysis, stress and deflection, and material selection — testing my ability to connect first-principles thinking across the full problem space.
Me postulé a través de una facultad o universidad. Acudí a una entrevista en Apple (Cupertino, CA) en abr 2026
Entrevista
Interview with hiring manager then virtual onsite. They ask you general mechanical engineering questions as well as questions dependent on type of team and skills they are looking for. Not bad overall just brush up on basic beam deflection, GD&T, Design analysis etc.
They gave me a take home tolerance analysis worksheet. It was essentially a tolerance stack up for one of their products and felt fairly straight forward. Thought I answered it well but ultimately they decided to move forward with other candidates.